Product Category

6-pin patch 2 shift toggle switch MSK-1133

The toggle switch is to switch on or off the circuit by turning the switch handle, so as to achieve the purpose of switching the circuit.

Quantity:

Share this:

Inquire

Product Description
Specifications
Certificates

Features:

100% brand new and high quality.

Easy to install and use.

Easy structure, mini body,

The toggle switch is to switch on or off the circuit by turning the switch handle, so as to achieve the purpose of switching the circuit. The commonly used varieties of toggle switch include single pole double position, single pole three position, double pole double position and double pole three position, etc. it is generally used in low-voltage circuit, with the characteristics of flexible sliding block action and stable and reliable performance. The toggle switch is mainly used in various instruments / instrument equipment, various electric toys, fax machines, audio equipment, medical equipment, beauty equipment, and other electronic product fields.

Specifications:

Product Name :SLIDE SWITCH

Model：MSK-1133

Ratings: 12V DC, 50mA (effective value)

Contact Resistance:≤70mΩ Insulation Resistance:≥100MΩ

Dielectric voltage proof:250V AC(50HZ or 60HZ)/1min

Operating Force:150±50gf

Operation life:Average fault-free life 10,000 times

SLIDE SWITCH CHARACTERISTICS

PRACTICAL TEMPERATURE RANGE

-16℃- +60℃. （Normal humidity, normal air pressure）

Storage Temperature Range

-20℃～65℃ （Normal humidity, normal air pressure）

ITEM	TEST CONDITIONS	PERFORMANCE
TERMINAL STRENGTH	A STATIC LOAD OF 300gf SHALL BE APPLIED TO THE TERMINAL FOR 15 SEC .IN ANY DIRECTION	ELECTRICAL CHARACTERISTICS SHALL BE SATISFIED WITHOUT DAMAGE OR EXCESSIVE LOOSENESS OF TERMINALS.
DISPLACEMENT OF ACTUATOR (KNOB)	A STATIC LOAD OF 10 N (1Kgf) SHALL BE APPLIED TO THE TOP OF THE ACTUATOR (KNOD) AND THEN DISPLACEMENT SHALL BE MEASURED TO THE DIRECTION OF THE ARROW.	THE LEVER SHALL HAVE NO SERIOUS DEFORMATION AND FUNCTION NORMALLY.
LIFE TEST	ENDURANCE WITHOUT LOADING: A SWITCH SHALL BE SUBJECTED TO 10,000 CYCLES AT A SPEED OF 15 TO 18 CYCLES PER MINUTE WITHOUT LOADING.	(1) CONTACT RESISTANCE 100mΩ MAX. (2) INSULATION RESISTANCE 50M Ω MIN. (3) WITHSTAND VOLTAGE AC 500V,1 MINUTE.AC 500V 1 分钟 (4) OPERATING FORCE ± 30% INITIAL VALUE. (5) WITHOUT DAMAGE TO PARTS ARCING OR BREAKDOWN ETC.
SOLDERABILITY TEST	THE TOP OF THE TERMINALS SHALL BE DIPPED 2mm IN THE SOLDER BATH OF 230± 10℃ FOR 2±0.5 SECONDS.	THE AREA OF SOLDERING. SHOULD BE OVER 75%.
RESISTANCE TO SOLDERING HEAT TEST	SOLDER BATH METHOD: SOLDER TEMPERATURE 250 ± 10 ℃ IMMERSION TIME 2 ± 0.5 SEC IMMERSION DEPTH UP TO THE SUPFACE OF THE BOARD THICLNESS OF PRINTED WIRING BOARD 1.6mm DIMENSIONS OFCOMPONENT HOLES I-N THE PRINTED WIRING BOARD SHALL BEIN-G ACCORDANCE WITH THOSE SPECIFIED IN THIS SPECIFICATION.	WITHOUT DEFORMATION OF CASE OR EXCES-SIVE LOOSENESS OF TEMINALS ELECTRICAL CHARACTERISTICS SHALL BE SATISFIED.
HUMIDITY TEST	THE SWITCH SHALL BE STORED AT A TEMPERATUREOF 40± 2℃ AND A HUMIDITY OF 90% TO 95% FOR 96 HOURS .THEN THE SWITCH SHALL BE MAINTAINED AT STANDARD ATMOSPHERIC CONDITION FOR 1 HOUR AFTER WHICH MEASUREMENT SHALL BE MADE.	THERE SHALL BE NO DEFORMATION OR CRACKS IN MOLDED PART.