RJ45 all inclusive lightless 8p8c network interface socket RJ45-56B03 RJ45 all inclusive lightless 8p8c network interface socket RJ45-56B03

RJ45 is composed of plug and socket. The connector composed of these two components is connected between wires to realize the electrical continuity of wires.

Quantity:
Share this:
  • Product Description
  • Specifications
  • Certificates

Features:

100% brand new and high quality.

Easy to install and use.

Easy structure, mini body,

RJ45 is a kind of connector of information socket (Communication outlet) in wiring system. The connector is composed of plug (connector, crystal head) and socket (module). The plug has 8 grooves and 8 contacts. RJ is the abbreviation of registered jack, which means "registered socket". In FCC (Federal Communications Commission standards and regulations), RJ is the interface of public telecommunication network, and RJ45 of computer network is the common name of standard 8-bit modular interface.

Distinguish RJ11

In the home ADSL modem, there will also be RJ11 interface, which is slightly smaller than RJ45 interface and is mainly used to connect telephone lines.

classification

According to the installation position of RJ45 module, it can be divided into four types: embedded type, carpet type, desk type and general type

According to the shielding performance, it can be divided into unshielded module and shielded module. When installing shielded cable system, the whole link must be shielded, including cables and connectors, and shielded information modules are needed.



Specifications:

Product Name : RJ45

Model: RJ45-56B03


RJ45  SPECIFICATIONS


Contact Current Rating: 1.5Ampere Minimum.


Temperature Range:   -25℃ to +85℃




ITEMTEST CONDITIONS
Requirements
Solder ability

Immerse the solder pin of the connector
in the solder bath at 245℃±3℃ for 3±
0.5seconds.

After dipped the pin in the flux for 5
seconds

Solder wetting
95% of immersed area must
show no voids,Pin holes.

Resistance to
soldering heat
Place the connector on the PCB,then
immerse the solder pin up to the
surface of the board in the solder bath
at 265℃±5℃ for 10 seconds.

1、 Without deformation of case or excessive
lossen.
2、 Electrical characteristics shall be satisfied.
Drop test

Drop 800mm under 10kg, 600mm under 10 ~ 20kg, at least 10 times according to one corner, three lines and six sides
The packaging box shall not be damaged or seriously deformed, the internal product packaging shall be in good condition, the material appearance and structure shall be in good condition, without deformation, wear, cracking and other problems, and the electrical performance, mechanical performance and environmental performance shall be normal;
Withstand heat

After the connector is exposed to a constant temperature and humidity bath with a temperature of 85 ± 2 ℃ for 96 hours, and then naturally dried at room temperature for 2 hours, the insulation part shall have no deformation, scratch and metal part shall have no discoloration.
Appearance: no obvious damage on
appearance and configuration

Withstand cold

After the connector is exposed to a constant temperature and humidity bath with a temperature of - 40 ± 2 ℃ for 96 hours, and then naturally dried at room temperature for 2 hours, the insulation part shall have no deformation, scratch and metal part shall have no discoloration.
Appearance: no obvious damage on
appearance and configuration


×

Contact Us

captcha